EZ Handrail EZG106 Manual de instrucciones descargar pdf (Pagina 21)

EZ Gate Instructions

EZ Gates can swing left or right depending on the hinge location. Standard hinges and gravity latch

are included with all EZ Gates. Note: Self closing hinges and pool child safety latch sold separately.

Step 1

1. Verify rough opening between posts is 1” greater than width of gate.

2. Set gate in opening and visually identify where hinges will attach to gate for the

desired swing direction.

3. Measure 3” down from the very top of gate and attach hinge to appropriate gate face

using the provided fasteners.

4. Attach 2

hinge 3” above the very bottom of the gate to the appropriate gate face.

5. Measure 4” down from the very top of gate and attach gate latch arm to

appropriate gate face using the provided fasteners.

6. Place (2) 2x4s on edge in the gate opening so the gate may rest in place while

attaching the hinges to the post.

7. Level gate in position and fasten top hinge to appropriate post face with a single

fastener only.

8. Confirm levelness and attach bottom hinge to post using all three fasteners

9. Complete installation of top hinge with remain two fasteners and remove 2x4’s.

Hold gate latch on latch arm, swing gate closed, mark holes and fasten latch to post.

Available gate sizes:

Typical Railing Heights:

Residential: 36”W x 36”H

Residential: 36”

Commercial 36”W x 42”H

Commercial: 42”

Pool Gate: 36”W x 48”H

Pool Fencing: 48” – 54” (check local codes)

Photo of the EZ Gate in Bronze with

pool code safety hardware:

• Self closing hinges

• Child safety pool latch

www.ezhandrail.com for videos 21

1 2 ... 16 17 18 19 20 21 22 23

Sin comentarios

EZ Handrail EZG106 Manual de instrucciones Pagina 21